Skip to content

HVAC

HVAC cost overview

A new HVAC system's price depends mostly on system type and sizing, not brand alone. Central air paired with a furnace, or an all-in-one heat pump, are priced differently, and within each type a higher SEER (efficiency) rating costs more upfront but lowers utility bills.

2 estimators in this trade.

What drives the price

Home size (system size)About 1,800 sq ft (3 tons), About 1,000 sq ft (1.5 tons), About 1,200 sq ft (2 tons), About 2,500 sq ft (4 tons), About 3,300 sq ft (5 tons)Price effect: ×0.975 to ×1.552
Efficiency (SEER2)Standard (SEER2 14-15), High (SEER2 16-17), Very high (SEER2 18-19), Premium (SEER2 20+)Price effect: ×1 to ×2.353

Price ranges by job

Control board replacementLow $250Typical $450High $800
Service call / diagnostic visitLow $50Typical $100High $200
Igniter (hot surface) replacementLow $100Typical $180High $300
Flame sensor replacementLow $75Typical $150High $240
Thermocouple / pilot assembly (older pilot-light furnaces)Low $100Typical $175High $300
Blower motor replacementLow $300Typical $600High $1,200
Draft inducer motor replacementLow $300Typical $650High $1,200
Gas valve replacementLow $200Typical $450High $800
Pressure switch replacementLow $150Typical $280High $400
High-limit switch replacementLow $100Typical $220High $375
Blower motor capacitor replacementLow $100Typical $180High $400
Thermostat replacementLow $100Typical $250High $600
Heat exchanger replacementLow $800Typical $1,500High $3,000
Annual furnace tune-upLow $70Typical $130High $250
Central air conditioner (cooling only)Low $3,000Typical $6,000High $15,000
Heat pump (heating and cooling)Low $4,200Typical $8,350High $15,000
Gas furnace (heating only)Low $3,800Typical $6,900High $12,000
Full system: central AC plus furnaceLow $5,000Typical $8,344High $28,000
Dual fuel: heat pump plus gas furnaceLow $7,500Typical $9,500High $12,000
Ductless mini-split (per zone)Low $1,150Typical $2,200High $3,100
Read more about hvac costs

Sizing the unit correctly for the home's square footage and climate (measured in tons of cooling capacity) matters more than most homeowners expect: an oversized or undersized system wastes money either way, so a contractor should run a load calculation rather than just matching the old unit's size.

Existing ductwork is often the biggest wildcard: if the ducts are damaged, poorly sealed, or the wrong size for a new system, repairing or replacing them adds significantly to the project and is usually quoted separately from the unit itself. Permits are typically required, and some regions have local incentives or rules tied to refrigerant type that affect which systems are available. This is not a DIY project: installing or servicing central HVAC equipment involves refrigerant handling, which legally requires EPA Section 608 certification, plus electrical and often gas line work that needs a licensed technician.

The estimator on this page calculates a low/typical/high range for a full new HVAC system installation, based on published market data. It does not price ductwork repairs, permits, or financing, so use it as a starting range and ask contractors to itemize ductwork and any electrical upgrades separately.

If the furnace still runs but has a problem, a repair is usually far cheaper than a new system. The furnace repair estimator here prices common fixes one at a time, from a diagnostic visit and a new igniter or flame sensor to a blower motor, control board or heat exchanger, so you can check a technician's quote and weigh it against replacing an older unit.

Frequently asked questions

How much does a new central air conditioner cost?

Sourced installed prices run from $3,000 to $15,000, with a typical $6,000 for cooling only. Home size and efficiency rating move the price within that range.

What does a heat pump installation cost?

A heat pump that heats and cools is sourced at $4,200 to $15,000, with a typical $8,350.

How much does a gas furnace cost to replace?

A gas furnace is sourced at $3,800 to $12,000, typically $6,900. Ductwork or venting changes are extra.

What does a full HVAC system cost?

A full system is sourced at $5,000 to $28,000, with a typical $8,344 for a home of about 1,800 sq ft. Ask for ductwork and electrical upgrades as separate lines.

How much does a furnace repair cost?

It depends on the part. A control board is sourced at $250 to $800 (typical $450), an igniter at $100 to $300, a blower motor at $300 to $1,200, and a heat exchanger at $800 to $3,000. A diagnostic visit is sourced at $50 to $200.

Can I install an HVAC system myself?

No. Handling refrigerant legally requires EPA Section 608 certification, and the job also involves electrical and often gas work, plus permits. Hire a licensed HVAC contractor and compare written quotes.